AML M3000 Guide de l'utilisateur télécharger pdf (Page 10)

American Microsystems, Ltd. M5000 Portable Data Terminal

Using Built-In Programs

Six programs are pre-programmed into the M5000 PDT for data collection. To use these programs,

select Copy Program. The prompts for each program (P1 through P6) are as they appear in the

display below. Comma delimited programs (P2C through P5C) are also included.

P1 P2 P3 P4 P5 P6

ITEM NUMBER P/N P/N P/N P/N

QTY QTY LOC QTY UOM QTY

DESCRIPTION

Rec 1 of 1 Rec 1 of 1 Rec 1 of 1 Rec 1 of 1 Rec 1 of 1 Rec 1 of 1

How to Load Sample P2 Program on the M5000 PDT

1. In the Main Menu, select Copy Program.

2. Arrow down and select sample P2

program. The prompt reads Copying P2 to RAM, then P2

Copied to RAM, press any key.

3. After you press any key, the Main Menu appears. The P2 program is loaded and ready to collect

data.

How to Collect Data on the M5000 PDT Using Sample

P2 Program

1. In the Main Menu, select Input. Choose

P2 from the

Select Program

list.

2. Select *New File* and input a filename. (You are now prompted to enter data: (P/N, QTY

and

Rec

1 of

1.)

3. When you finish entering data, press exit. The M5000 PDT prompts you with a confirmation

message to Exit Data Entry Are You Sure? (No), to exit press Y or toggle the arrow key to select

yes.

4. Press Y to Save Data File? or toggle the arrow key to select yes. The M5000 PDT returns you to

the Select Program menu where you can choose another program or exit and return to the Main

Menu.

How to Send a Program to the M5000 PDT

We assume that the serial cable is connected to an available com port and all default communication

parameters (xmodem, 9600, N, 8, 1) are used. The following steps can be used to send a program to

the M5000 PDT.

1. Using the M5000 PDT select Communications, choose Receive.

2. Select RS-232 Serial

under Communications Mode, (prompt shows Waiting for Connect).

3. On your PC, select Send icon or you can go into the Communications Menu and choose Send

File.

4. Select a program file to send, choose ok, and select Send.



Note: If an error occurs, select Setup to choose an available com port or repeat steps 2 and 3.

The M5000 PDT displays Receive Complete

when the file is received.

5. Press exit to return to the M5000 PDT Main Menu.

Warning!

When duplicate filenames are used during data file transmission, the

new file automatically overrides the existing file.

All previous data will be lost.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 37 38

Commentaires sur ces manuels

Pas de commentaire

AML M3000 Guide de l'utilisateur Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Lecteurs de codes-barres AML M3000