AML M3000 Guide de l'utilisateur télécharger pdf (Page 14)

American Microsystems, Ltd. M5000 Portable Data Terminal

Alternate Scan Code

—

this option is used only for computers that run Scan Code Set 3

(some Xwindows terminals and concurrent DOS).

Serial Port Settings

—

allows the Wedge Programmer to select the baud rate,

parity and data bits and are applicable only in RS-232 serial mode.

Baud Rate

—

sets the transmission speed for the serial port on the wedge and must match the

baud rate of the RS-232 device. Select one of the following:

300 2400 19200

600 4800 38400

1200 9600

Data Bits

—

sets the character length (number of data bits per character) for serial data and

must match the data bits setting of the RS-232 device. Select either 7 or 8.

Parity

—

the parity setting must match the parity setting of the RS-232 device. Parity is used to

provide a self-checking method for data transmission. Select one of the following:

None

Even

Odd

Mark

Transmit Speed

—

this option incorporates a slide bar and sets the speed at which data will

be transmitted to the computer. Older computer systems may require the transmission speed set to

a slower rate.

Diagnostics

—

option that executes a self-test program and performs the following tests on

the M5000 PDT. Close the Diagnostics window when tests are completed.

RAM Test

ROM Checksum

EEPROM Test

Character Set

LED Test

RS-232 Serial Loopback Test (loopback connector required)

RTS/CTS Loopback Test (loopback connector required)

Status Log

How to Upload Collected Data

Using the M5100 Keyboard Wedge

We assume that you followed the previous steps in this section, connecting the M5100 Keyboard

Wedge and the interface cable, you are now ready to upload the collected data. The cursor must be in

the active application for you to upload your data. You can use Notepad for testing your M5000 PDT

program settings.

1. In the Main Menu of the

M5000 PDT, choose Communications, select Send, Data Files.

2. From your PC, select the M5000 Programmer, select Communications, Send and then select the

collected data file. Your data then begins transmitting into your application and appears as

keyboard data.

3. Once your file is successfully transmitted and a key is pressed you are prompted with a

confirmation message to Erase Uploaded Data Files? (No), if desired, press Y or toggle an arrow

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 37 38

Commentaires sur ces manuels

Pas de commentaire

AML M3000 Guide de l'utilisateur Page 14

Commentaires sur ces manuels

Produits connexes et manuels pour Lecteurs de codes-barres AML M3000